MtimeSourceMonotonic time values.
Mtime has platform independent support for monotonic wall-clock time. This time increases monotonically and is not subject to operating system calendar time adjustments.
Time spans represent non-negative monotonic time spans between two monotonic clock readings. Timestamps represent system-relative monotonic timestamps, their absolute value is meaningless but they can be compared across the processes of an operating system run.
Mtime_clock provides access to a system monotonic clock.
The type for non-negative monotonic time spans. They represent the difference between two monotonic clock readings. If the platform's clock has nanosecond resolution the representation guarantees that the function Mtime_clock.elapsed can measure up to approximatively 584 Julian year spans before silently rolling over (unlikely since this is in a single program run).
Note. Only use timestamps if you need inter-process time correlation, otherwise prefer Mtime_clock.elapsed and counters.
The type for monotonic timestamps relative to an indeterminate system-wide event (e.g. last startup). Their absolute value has no meaning but can be used for inter-process time correlation.
to_uint64_ns t is t as an unsigned 64-bit integer nanosecond timestamp. The absolute value is meaningless.
to_uint64_ns t is t is an unsigned 64-bit integer nanosecond timestamp as a timestamp.
Warning. Timestamps returned by this function should only be used with other timestamp values that are know to come from the same operating system run.
span t t' is the span between t and t' regardless of the order between t and t'.
add_span t s is the timestamp s units later than t or None if the result overflows.
sub_span t s is the timestamp s units earlier than t or None if the result underflows.
pp ppf t formats t as an unsigned 64-bit integer nanosecond timestamp. Note that the absolute value is meaningless.
dump ppf t formats an unspecified raw representation of t on ppf.
The following convenience constants relate time scales to seconds. Used as multiplicands they can be used to convert these units to and from seconds.
The constants are defined according to SI prefixes on seconds and accepted non-SI units. Years are counted in Julian years (365.25 SI-accepted days) as defined by the International Astronomical Union (IAU).
ns_to_s is 1e-9 the number of seconds in one nanosecond.
us_to_s is 1e-6, the number of seconds in one microsecond.
ms_to_s is 1e-3, the number of seconds in one millisecond.
min_to_s is 60., the number of seconds in one SI-accepted minute.
hour_to_s is 3600., the number of seconds in one SI-accepted hour.
day_to_s is 86_400., the number of seconds in one SI-accepted day.
year_to_s is 31_557_600., the number of seconds in a Julian year.
s_to_ns is 1e9 the number of nanoseconds in one second.
s_to_us is 1e6, the number of microseconds in one second.
s_to_ms is 1e3, the number of milliseconds in one second.
s_to_min is 1. /. 60., the number of SI-accepted minutes in one second.
s_to_hour is 1. /. 3600., the number of SI-accepted hours in one second.
s_to_day is 1. /. 86400., the number of SI-accepted days in one second.
s_to_year is 1. /. 31_557_600., the number of Julian years in one second.